V-SHAPED SUPPORT BLOCK 1-5/16 + CLAMP-567 - 567
STT52588
Prix régulier
$812.19
Preorder today
- The clamp is smaller than the block's outer width, but has an adjustable side screw to support the block and prevent it from tilting.
- The V at the stepped end is perpendicular to the base and is convenient for holding shoulder studs, pins, etc.
- A clearance hole for drilling or removing studs is provided in the block
- The block has four 3/8-16 tapped holes
- The block is hardened and precision ground
- The clamp is a solid forged piece
- Can be used on its base, on the end, or on either side
- Used for general workshop and fitting work, as well as for holding stock in place during light milling, drilling, and grinding operations.
- The clamp is smaller than the block's outer width, but has an adjustable side screw to support the block and prevent it from tilting.
- The V at the stepped end is perpendicular to the base and is convenient for holding shoulder studs, pins, etc.
- A clearance hole for drilling or removing studs is provided in the block
- The block has four 3/8-16 tapped holes
- The block is hardened and precision ground
- The clamp is a solid forged piece
- Can be used on its base, on the end, or on either side
- Used for general workshop and fitting work, as well as for holding stock in place during light milling, drilling, and grinding operations.
STT52588
Prix régulier
$812.19
Preorder today
- The clamp is smaller than the block's outer width, but has an adjustable side screw to support the block and prevent it from tilting.
- The V at the stepped end is perpendicular to the base and is convenient for holding shoulder studs, pins, etc.
- A clearance hole for drilling or removing studs is provided in the block
- The block has four 3/8-16 tapped holes
- The block is hardened and precision ground
- The clamp is a solid forged piece
- Can be used on its base, on the end, or on either side
- Used for general workshop and fitting work, as well as for holding stock in place during light milling, drilling, and grinding operations.
- The clamp is smaller than the block's outer width, but has an adjustable side screw to support the block and prevent it from tilting.
- The V at the stepped end is perpendicular to the base and is convenient for holding shoulder studs, pins, etc.
- A clearance hole for drilling or removing studs is provided in the block
- The block has four 3/8-16 tapped holes
- The block is hardened and precision ground
- The clamp is a solid forged piece
- Can be used on its base, on the end, or on either side
- Used for general workshop and fitting work, as well as for holding stock in place during light milling, drilling, and grinding operations.