Machinist's Square 1-5/8-457C - 457C
STT52429
Prix régulier
$599.49
Preorder today
- Use with the 30-degree angle or direct mounting
- The blades and beams are hardened and ground.
- It is also very useful for the modulators to check the angles and air currents on the patterns
- The beam of this square is graduated to show the blade adjustment in degrees.
- The blades can be set to any angle up to 10 degrees, on either side of 0 degrees, and the angle is indicated by the line on the pointer.
- The graduated scale is crooked, marked 32nds of an inch on one side and 64ths on the other, it measures 5/32" wide by 1-5/8" long and is cut at one end to a width of 3/32".
- The offset limp, which is used where it would be impossible to insert the straight limp, extends approximately 1-1/2 inches beyond the square, is 1/8 inch wide, and both sides of each edge are beveled to provide visual contact with the line
- Use with the 30-degree angle or direct mounting
- The blades and beams are hardened and ground.
- It is also very useful for the modulators to check the angles and air currents on the patterns
- The beam of this square is graduated to show the blade adjustment in degrees.
- The blades can be set to any angle up to 10 degrees, on either side of 0 degrees, and the angle is indicated by the line on the pointer.
- The graduated scale is crooked, marked 32nds of an inch on one side and 64ths on the other, it measures 5/32" wide by 1-5/8" long and is cut at one end to a width of 3/32".
- The offset limp, which is used where it would be impossible to insert the straight limp, extends approximately 1-1/2 inches beyond the square, is 1/8 inch wide, and both sides of each edge are beveled to provide visual contact with the line
STT52429
Prix régulier
$599.49
Preorder today
- Use with the 30-degree angle or direct mounting
- The blades and beams are hardened and ground.
- It is also very useful for the modulators to check the angles and air currents on the patterns
- The beam of this square is graduated to show the blade adjustment in degrees.
- The blades can be set to any angle up to 10 degrees, on either side of 0 degrees, and the angle is indicated by the line on the pointer.
- The graduated scale is crooked, marked 32nds of an inch on one side and 64ths on the other, it measures 5/32" wide by 1-5/8" long and is cut at one end to a width of 3/32".
- The offset limp, which is used where it would be impossible to insert the straight limp, extends approximately 1-1/2 inches beyond the square, is 1/8 inch wide, and both sides of each edge are beveled to provide visual contact with the line
- Use with the 30-degree angle or direct mounting
- The blades and beams are hardened and ground.
- It is also very useful for the modulators to check the angles and air currents on the patterns
- The beam of this square is graduated to show the blade adjustment in degrees.
- The blades can be set to any angle up to 10 degrees, on either side of 0 degrees, and the angle is indicated by the line on the pointer.
- The graduated scale is crooked, marked 32nds of an inch on one side and 64ths on the other, it measures 5/32" wide by 1-5/8" long and is cut at one end to a width of 3/32".
- The offset limp, which is used where it would be impossible to insert the straight limp, extends approximately 1-1/2 inches beyond the square, is 1/8 inch wide, and both sides of each edge are beveled to provide visual contact with the line